Garbage Disposal Installation Cost: DIY vs Pro

Garbage disposal installation cost is usually about $200 to $650. HomeGuide puts a replacement with existing connections at $200 to $550 and a new install, where there was no disposal before, at $250 to $650. Angi’s and Fixr’s averages are $550 and $500. The unit itself is often the smaller part of the bill. This guide shows what a quote should include line by line, what changes for a first-time install, how long disposals last, and when doing it yourself makes sense.

The short answer

  • Replacement: $200 to $550 with existing plumbing and wiring (HomeGuide). Angi’s average is $550; Fixr’s is $500.
  • New install: $250 to $650 (HomeGuide), more if you need a new outlet ($150 to $350) or drain changes.
  • Unit only: about $75 to $400 depending on the motor, from 1/3 to 1 horsepower (HomeGuide).
  • Lifespan: about 8 to 12 years (HomeGuide); stainless steel models can last longer.

Garbage disposal installation cost calculator

Pick your job and options. Prices come from HomeGuide. The result table shows each item a full quote should cover, so you can compare quotes line by line. A rough estimate, not a quote.

Disposal unit
Installation labor
Old unit removal
New outlet
Drain or piping changes
Electrical permit

Not included: counter or cabinet changes, a new sink, hard-to-reach removals (Angi: $50 to $100 more) or local price differences. Rounded to the nearest $10.

Wrench on a stainless steel kitchen sink before a garbage disposal installation
Labor for a straight replacement runs about $75 to $250, according to HomeGuide. Photo: Konstantin Mishchenko / Pexels.

Garbage disposal installation cost: replacement vs new

JobHomeGuideFixrAngi
Replacement (existing wiring and drain)$200 to $550$350 to $700Average $550
New install (none before)$250 to $650$300 to $600—
DIY (unit and tools)——About $75 and up
$0 $200 $400 $600 $800 HomeGuide, replacement HomeGuide, new install Fixr Angi Bar = typical range · dot = average
Sources: HomeGuide, Fixr and Angi. Read on November 16, 2026.

A replacement is the simpler job: unplug, swap and reconnect. A first-time install may need an outlet under the sink, a switch, drain changes and sometimes a permit, which is why it costs more.

Garbage disposal installation cost by motor size

MotorHousehold (Fixr)Unit only (HomeGuide)Unit only (Fixr)
1/3 HP1 to 2 people$75 to $125$50 to $150
1/2 HP1 to 4 people$100 to $150$100 to $225
3/4 HP3 to 6 people$125 to $300$175 to $300
1 HP5 to 8 people$175 to $400$200 to $400

HomeGuide adds that batch-feed models, which only run with the lid in place, cost $200 to $350, against $75 to $300 for common continuous-feed units. Angi notes that the batch-feed cover helps prevent accidental starts, which suits homes with young children.

Kitchen sink with a chrome faucet
A first-time installation may need a new outlet under the sink and changes to the drain. Photo: Martin Lang / Pexels.

Electrical work in a garbage disposal installation cost

Angi says many disposals plug into a standard 120-volt outlet and draw 5 to 10 amps, but some local codes require a dedicated 15-amp circuit with GFCI and AFCI protection. HomeGuide prices a new outlet at $150 to $350 and an electrical permit at $50 to $350. Fixr puts a corded unit at $300 to $450 installed and a hardwired one at $400 to $600.

Can you install a garbage disposal yourself?

HomeGuide says DIY is reasonable only when you are swapping in a unit of the same size, with existing wiring and pipes in good condition. Changing the model type, moving the unit, or any new electrical or plumbing work is a job for a pro. Angi warns that a poor DIY installation can cause leaks that damage cabinets, floors and plumbing.

Safety

  • Turn off the power at the breaker, not just the wall switch, before touching the unit.
  • Never put your hand inside a disposal. Use tongs, and the hex key or wrench made for the unit to free a jam.
  • New circuits and outlets should be done by a licensed electrician, with a permit where your city requires one.

Repair or replace?

HomeGuide puts repairs at $100 to $250 and suggests replacing when the repair costs more than half of a replacement or the unit is more than 8 years old. Angi lists these signs of a disposal near the end: it doesn't run when powered, it leaks from the body, it grinds weakly or drains slowly, you press the reset button often, or you hear metal-on-metal noises.

Watch: How to Install a Garbage Disposal

Video: “How to Install a Garbage Disposal” by This Old House on YouTube. We didn't make this video; it shows how the work is done. Prices and local rules in it may differ from yours. This is a job for a licensed pro.

How we worked this out

We read the garbage disposal installation cost guides of HomeGuide, Angi and Fixr on November 16, 2026. Note that Fixr's page was last updated on January 31, 2025. We did not install any disposals or get quotes.

Questions homeowners ask

How much does a plumber charge to install a garbage disposal?

HomeGuide puts plumber labor for a replacement at $100 to $250. Fixr estimates about three hours at $125 an hour, or roughly $300 of a $500 job.

How much does it cost to replace a garbage disposal?

About $200 to $550 with existing connections (HomeGuide). Angi's average is $550.

How long does a garbage disposal last?

About 8 to 12 years (HomeGuide). Angi says 5 to 10 years on average, and stainless steel models up to 15.

Do I need an electrician to install a garbage disposal?

Not for a like-for-like swap with an existing outlet. For a first-time install that needs a new outlet or circuit, yes. HomeGuide prices a new outlet at $150 to $350.

The verdict

A garbage disposal usually costs $200 to $650 installed, and a straight replacement sits at the low end. A first-time install costs more because of the outlet, drain changes and possibly a permit. Compare quotes line by line using the calculator's breakdown, pick a motor size for your household, and leave any new wiring to a licensed electrician.

Sources We Checked

About the author

Khalid is studying mechanics and works as a welder. He is not a plumber or an electrician. He writes these cost guides by comparing published price data and official safety sources, and he lists every source he used. No brand paid for this guide, and it has no affiliate links. More about Khalid · How we research

Scroll to Top