Tile Installation Cost: Floors, Walls, and Backsplashes

Tile installation cost usually runs about $10 to $50 per square foot installed, according to HomeGuide, with labor alone at $8 to $20 per square foot. Angi puts a typical tile floor at $15 to $20 per square foot all-in, about $1,900 for an average project. The tile you choose, the room and the condition of the surface underneath drive most of the range. This guide breaks it down by tile type and room, covers removal and prep, explains how much extra tile to buy, and includes a calculator.

The short answer

  • Installed: $10 to $50 per sq ft (HomeGuide); Angi says $15 to $20 per sq ft for a typical floor, about $1,900 per project.
  • Labor only: $8 to $20 per sq ft (HomeGuide) or $3 to $15 (Angi).
  • Backsplash: about $1,100 on average for 20 to 40 sq ft (HomeGuide).
  • Old tile: removal adds about $2 to $7 per sq ft (HomeGuide).

Tile installation cost calculator

Measure length × width of each surface and add them up. Installed prices per square foot come from HomeGuide. We don’t add extra for waste here, because these are installed prices. If you buy the tile yourself, order about 10% extra, or 15% for diagonal or complex layouts (our suggestion). A rough estimate, not a quote.

Tile, installed
Removal
Radiant floor heat

Not included: subfloor repair or leveling (Angi: leveling $2 to $30 per sq ft), cement board and waterproofing, trim pieces, minimum charges or local price differences. Rounded to the nearest $10.

Gloved hand setting floor tiles with leveling clips and spacers during a tile installation
Labor is $8 to $20 per square foot of the tile installation cost, according to HomeGuide. Photo: Vladimir Srajber / Pexels.

Tile installation cost by tile type

TileInstalled per sq ft (HomeGuide)Material per sq ft (Angi)
Ceramic$12 to $40$0.50 to $7
Porcelain$15 to $50$3 to $10
Natural stone$10 to $50$5 to $35
MarbleHigher end of stone$5 to $25
TravertineIn stone range$3 to $17
Subway or rectangular$7 to $35—
Glass or mosaic$20 to $100Glass $200 to $300 (as listed)
$0 $37 $75 $112 $150 Subway or rectangular Natural stone Ceramic Porcelain Glass or mosaic Bar = installed price per sq ft
Source: HomeGuide tile installation cost guide (2026). Read on November 16, 2026.

Angi's material prices are much lower than HomeGuide's installed prices because they leave out labor, setting materials and prep. Its glass tile figure looks unusually high, so compare actual product quotes for glass.

Cost to install tile by room

ProjectTypical areaHomeGuide
Kitchen backsplash20 to 40 sq ft$200 to $2,000 (average about $1,100)
Bathroom floor40 to 160 sq ft$400 to $8,000
Shower retile42 to 120 sq ft$420 to $6,000 ($7 to $25 per sq ft)
Kitchen floor130 to 184 sq ft$1,300 to $9,200
Bathroom walls104 to 274 sq ft$1,000 to $13,700
Living area floor200 to 320 sq ft$2,000 to $16,000
Bathroom wall with small mosaic tiles
Glass and mosaic tile can cost $20 to $100 per square foot installed because it takes much longer to set (HomeGuide). Photo: Alexander F Ungerer / Pexels.

Backsplash installation cost

HomeGuide's average for a kitchen backsplash is about $1,100, with most between $500 and $1,700 for 20 to 40 square feet. By material, installed: ceramic $6 to $28, porcelain $7 to $30, subway $7 to $35, glass or marble $10 to $45 per square foot. Labor alone runs $5 to $20 per square foot. Because backsplashes are small, an installer's minimum charge can matter more than the price per square foot.

Removal and prep: the hidden part of tile flooring installation cost

  • Removing old tile: $2 to $7 per sq ft (HomeGuide); Angi says about $5, including repairs to the subfloor from removal.
  • Floor leveling: $2 to $30 per sq ft (Angi).
  • Cement board and vapor barrier: HomeGuide says they are needed in bathrooms and outdoor areas.
  • Radiant floor heat: $7 to $17 per sq ft installed (HomeGuide).

Tile is only as good as the floor under it. A bouncy or uneven subfloor cracks tile and grout, so ask how the installer will check and prepare it before they quote.

Dust and old floors

Silica and asbestos

  • OSHA says materials such as stone, concrete, mortar, ceramics and bricks contain crystalline silica, and that cutting, sawing, grinding or drilling them creates fine dust. Breathing it raises the risk of silicosis, an incurable lung disease, as well as lung cancer, COPD and kidney disease.
  • Ask installers to cut tile outside or with wet saws, and keep children and pets away from the work area.
  • The EPA lists vinyl floor tiles among older products that may contain asbestos. Don't break up or sand old vinyl tile until it has been tested.

Watch: How to Tile a Bathroom Floor

Video: “How to Tile a Bathroom Floor” by This Old House on YouTube. We didn't make this video; it shows how the work is done. Prices and local rules in it may differ from yours.

How we worked this out

We read the 2026 tile installation and backsplash guides of HomeGuide, Angi's tile floor guide, OSHA's silica overview and the EPA's asbestos page on November 16, 2026. The 10% and 15% waste allowances are our own suggestions. We did not install any tile or get quotes.

Questions homeowners ask

How much does it cost to install tile per square foot?

About $10 to $50 per sq ft installed (HomeGuide), with labor at $8 to $20. Angi puts a typical tile floor at $15 to $20 per sq ft all-in.

How much does a tile backsplash cost?

About $1,100 on average for 20 to 40 sq ft, with most between $500 and $1,700 (HomeGuide).

How much does it cost to tile a bathroom floor?

HomeGuide gives $400 to $8,000 for 40 to 160 sq ft, depending on the tile and prep.

How much extra tile should I buy?

None of the cost guides gives a figure. We suggest about 10% extra for simple layouts and 15% for diagonal or complex patterns, plus a box kept aside for future repairs.

The verdict

Tile usually costs $10 to $50 per square foot installed, and porcelain and natural stone sit toward the top. Removal and floor prep can add as much as the tile itself, so get them priced separately. Order a little extra for cuts, insist on dust control when tile is cut, and test old vinyl flooring for asbestos before anyone breaks it up.

Sources We Checked

About the author

Khalid is studying mechanics and works as a welder. He is not a tile setter or a contractor. He writes these cost guides by comparing published price data and official safety sources, and he lists every source he used. No brand paid for this guide, and it has no affiliate links. More about Khalid · How we research

Scroll to Top