Well Pump Replacement Cost: Submersible vs Jet Pumps

Well pump replacement cost usually runs about $1,000 to $2,500 installed, with national averages of $1,800 (HomeGuide) and $1,899 (Angi). A shallow-well jet pump can cost well under $1,000, while a constant-pressure or solar system can pass $5,000. The type of pump depends mostly on how deep your well is. This guide compares the main types, explains when the pressure tank should be replaced at the same time, and covers the water testing the CDC recommends after any work on a well.

The short answer

  • Typical installed price: $1,000 to $2,500 (HomeGuide, average $1,800); Angi’s average is $1,899.
  • By type: shallow jet $400 to $1,000, deep jet $500 to $1,400, submersible $1,000 to $2,500 installed (HomeGuide).
  • Pressure tank: $800 to $1,500 installed (HomeGuide). Pumps and tanks both last about 10 to 15 years.
  • After the work: the CDC says to test your well water after you replace or repair any part of the well system.

Well pump replacement cost calculator

Pick the pump that suits your well depth. Installed prices come from HomeGuide, and the pressure tank range from HomeGuide’s tank guide. A rough estimate, not a quote.

Well pump, installed
Pressure tank
Pressure switch

Not included: water testing, new wiring, well rehabilitation, drilling a new well ($5,300 to $9,000 for 150 feet, HomeGuide) or local price differences. Rounded to the nearest $100.

Technician adjusting a water pump during a well pump replacement
Labor for a well pump replacement runs about $250 to $800, and over $1,000 for difficult installs, according to HomeGuide. Photo: Bulat843 / Pexels.

Well pump replacement cost by pump type

Pump typeBest forInstalled (HomeGuide)Pump only (Angi)
Shallow jetWells up to about 25 ft$400 to $1,000$450 to $1,500
Deep jetWells about 50 to 100 ft$500 to $1,400$800 to $2,200+
SubmersibleDeep wells (often 200 to 300 ft or more, This Old House)$1,000 to $2,500$1,000 to $2,500+
Constant pressureSteady pressure for several fixtures$2,000 to $5,000$1,300 to $4,000+
SolarOff-grid or remote wells$1,500 to $6,500$1,800 to $6,500+
$0 $2k $4k $6k $8k Shallow jet Deep jet Submersible Solar Constant pressure Bar = installed price range
Source: HomeGuide well pump cost guide (2026). Read on November 16, 2026.

Usually you replace like with like: the depth of the well decides the pump type. Jet pumps sit above ground and pull water up; submersible pumps sit down in the well and push it up.

Well pump replacement cost: how the guides compare

The three guides land close together. HomeGuide gives $1,000 to $2,500 with an average of $1,800; Angi gives $975 to $2,824 with an average of $1,899; and This Old House, using Home Depot pump prices, gives $900 to $2,500 installed. Angi's prices by well depth run much higher for deep wells: $2,000 to $10,000 or more for pumps in wells over 150 feet.

Replace the pressure tank too?

The pressure tank stores water under pressure so the pump doesn't start every time you open a tap. HomeGuide puts a replacement at $800 to $1,500 installed, about $1,000 on average, and gives tanks the same 10- to 15-year life as pumps. Angi notes that replacing the whole system can be cheaper than replacing one part when the pump and tank are combined. If your tank is as old as the pump, replacing both at one visit saves a second call-out.

Tank sizeInstalled (HomeGuide)
20 to 29 gallons$450 to $1,000
40 to 59 gallons$600 to $1,600
80 to 99 gallons$850 to $2,300
Pressure gauges and water pipes
A pressure tank and switch keep water pressure steady between pump cycles. Photo: Nothing Ahead / Pexels.

Repair, or pay the well pump replacement cost?

Small parts are cheap. HomeGuide prices a pressure switch at $25 to $100 and a tank bladder at $50 to $100, while a new pump motor costs $500 to $1,000. Angi says repairs for significant problems often cost as much as, or more than, a replacement, and that pumps typically need replacing every 10 to 15 years.

Angi's warning signs include low or no water at the taps, a pump that runs nonstop, unusual noises, higher electric bills, sediment or air in the water, and dirty or foul-smelling water.

Safety and water testing

After any work on your well

  • The CDC says to test your well water at least once a year for total coliform bacteria, nitrates, total dissolved solids and pH.
  • It also says to test whenever you replace or repair any part of the well system, or after flooding near the well.
  • Private wells aren't covered by EPA's public drinking water rules. The CDC says the owner is responsible for testing.
  • Well pumps run on high-voltage circuits. Pulling a submersible pump is heavy work; leave it to a licensed well contractor.

For testing, ask your local health department; the CDC says local government can help you get your water tested.

Watch: How to Diagnose Problems with Well Water Systems

Video: “How to Diagnose Problems with Well Water Systems” by This Old House on YouTube. We didn't make this video; it shows how the work is done. Prices and local rules in it may differ from yours. This is a job for a licensed pro.

How we worked this out

We read the 2026 well pump and pressure tank guides of HomeGuide, Angi's and This Old House's well pump guides (This Old House updated March 5, 2026) and the CDC's well water testing guidelines on November 16, 2026. We did not work on any wells or get quotes.

Questions homeowners ask

How much does it cost to replace a well pump?

About $1,000 to $2,500 installed, with averages of $1,800 (HomeGuide) and $1,899 (Angi). Shallow jet pumps cost less; constant-pressure and solar systems more.

How long does a well pump last?

About 10 to 15 years with proper care, according to HomeGuide and Angi. The well itself can last 40 years or more (HomeGuide).

How much does a well pressure tank cost?

About $800 to $1,500 installed, around $1,000 on average (HomeGuide). Small tanks start near $450 installed.

Do I need to test my water after replacing a well pump?

Yes. The CDC recommends testing whenever you replace or repair any part of your well system, plus once a year for bacteria, nitrates, dissolved solids and pH.

The verdict

A well pump usually costs $1,000 to $2,500 to replace, and the depth of your well decides which type you need. If your pressure tank is as old as the pump, ask the contractor to check it before deciding whether to replace both. Use a licensed well contractor, and test your water after the work, as the CDC recommends.

Sources We Checked

About the author

Khalid is studying mechanics and works as a welder. He is not a well contractor or a plumber. He writes these cost guides by comparing published price data and official safety sources, and he lists every source he used. No brand paid for this guide, and it has no affiliate links. More about Khalid · How we research

Scroll to Top